Camera – Forward Facing (Remove and Replace)
FRT No: 17231002
Removal
-
- Use a trim tool to release the upper camera cover from the windshield bracket.
Caution:Â Take care not to damage component(s).Note:Â The following image shows the rear view mirror still installed.
- Remove the screws (x4) that secure the camera mounting plate to the windshield bracket.
- Use a trim tool to release the upper camera cover from the windshield bracket.
-
- While supporting the camera and mounting plate, disconnect the electrical connector from the rear of the camera by pulling the gold-colored tab away from the camera.
- While supporting the camera and mounting plate, disconnect the electrical connector from the rear of the camera by pulling the gold-colored tab away from the camera.
- Remove the screws (x3) that secure the camera to the mounting plate.
Installation
Caution:Â Do not touch the camera lens at any point during this procedure.
-
- Loosely install the center screw that secures the mounting plate to the camera. Do not torque the screw at this time.
- Loosely install the center screw that secures the mounting plate to the camera. Do not torque the screw at this time.
- Loosely install the RH screw that secures the mounting plate to the camera. Do not torque the screw at this time.
- Loosely install the LH screw that secures the mounting plate to the camera. Do not torque the screw at this time.
- Torque the screws (x3) in the order shown (torque 3 Nm).
- While supporting the camera and mounting plate, connect the electrical connector to the rear of the camera.
- Install the screws (x4) that secure the camera mounting plate to the windshield bracket (torque 3 Nm).
This is a demo advert, you can use simple text, HTML image or any Ad Service JavaScript code. If you're inserting HTML or JS code make sure editor is switched to 'Text' mode.