Tesla Model S Front Tie Rod Ends — Steering Linkage
Tesla Model S 2012–03/2021 • Front steering tie rod ends • OEM cross-ref: 6007071-00-B / 600707100B
Gruber’s high-quality front tie rod ends for Tesla Model S are engineered to address the common symptoms that show up as mileage climbs. Worn ball joints that cause clunking or knocking, sloppy steering feel, wandering, or steering wheel vibration. These are direct-fit steering components designed specifically for the Model S front suspension.
Experiencing suspension issues doesn’t mean your Tesla is a lemon. Like any vehicle, wear items such as wipers, brakes, tires, control arms, bushings, and tie rod ends eventually need replacement. Electric vehicles are inherently reliable thanks to fewer moving parts than gas cars, but the suspension still works hard every mile and will show wear over time.
Why these fail
- High mileage and rough roads can cause ball joint wear at the tie rod end.
- Worn joints lead to clunking or knocking over bumps and during low-speed maneuvers.
- Excess play in the joint can cause sloppy steering, wandering, or tramlining at highway speeds.
- Uneven toe angles from loose tie rods may create steering wheel vibration and irregular tire wear.
- Seals age and crack, allowing moisture and contaminants to break down the joint’s internal surfaces.
Our solution
- Direct-fit replacement for Tesla Model S front tie rod ends (2012–March 2021 production).
- Precision ball joints restore tight, confident steering feel and on-center stability.
- Engineered for EV weight and load characteristics specific to the Tesla Model S chassis.
- OEM-style geometry maintains correct steering angles when paired with a proper alignment.
- Gruber-vetted quality — components selected for use in our own high-mileage Tesla service fleet.
- Alignment-ready — designed to be adjusted precisely during a post-install wheel alignment.
At-a-glance specs
| Application |
Front steering tie rod ends (Tesla Model S) |
| Compatible vehicles |
Tesla Model S (2012 – March 2021)
All drivetrain variants within these years (where OEM part numbers match) |
| Position |
Front axle, steering linkage (tie rod ends) |
| Function |
Connects steering rack to front knuckles and sets toe angle |
| Construction |
Ball-and-socket joint with sealed boot; threaded adjustment for toe setting |
| Recommended service |
Professional installation followed by a full 4-wheel alignment after any tie rod, control arm, bushing, or ball joint replacement |
| OEM reference |
Tesla 6007071-00-B
Tesla 600707100B |
Service & coverage
These tie rod ends are intended for Tesla Model S vehicles built from 2012 through March 2021, where the factory steering system uses the OEM part numbers listed above. Any time you replace front suspension components such as control arms, bushings, or ball joints, a professional alignment is strongly recommended to ensure proper tracking, safe handling, and even tire wear.
💡
Maintenance tip: When replacing tie rod ends, mark the original thread position before removal and count turns during installation. This will get your toe setting close to spec and make the alignment process faster and more accurate. Always torque all fasteners to Tesla specifications.
🛠️
Not sure if this matches your steering setup?
Share your VIN and build date with the Gruber Motors team, and we’ll confirm compatibility and help you choose the correct tie rod components before you schedule suspension or alignment work.
